M1 BLOCK SIGNALLING LINKED MODULE
Introduction
The BLOCKsignalling module M1 has been designed to carry out a pre-programmed function when it is triggered, such as powering a section of track to move a train forward.
It then it waits until a train reaches the infra-red sensor.
At this point, the module completes the action (eg stops the train) and signals on one of its outputs that the task has been completed (the "DONE" terminal).
The DONE output would normally be connected to the trigger ("TRIG" input) of another module of the same type, which would then carry out its operation.
By linking several modules in series, successive actions can be carried out one after another.
If the modules are connected in a loop, the operation will continue indefinitely.
It the loop is not complete, the action can be started by an input (such as pressing a button) and will continue until the last module has completed its task.
The final output could be connected to an led to show the sequence has been completed.
The power input is designed for 12V DC, SEE PART NO MT12 OR MT16
Reverse polarity will not damage the module, although the module will not function.
SEE PDF FILE BELOW FOR FULL COLOUR INSTRRUCTIONS.