PC1 TRAIN TECH SIGNLE POINT DCC CONTROLLER.
This point controller allows you to easily change points on DCC
The PC1 One-Touch DCC™ Point Controller enables you to quickly and easily control most popular 2-position 12-16V point motors,
eg Peco, Hornby etc. Some coupling uncouplers and semaphore signals can also be controlled by point motors and so can also be controlled by this module.
Like all of our DCC modules it takes all of its power from the standard 2 wire DCC track or controller output and each also has a built in CDU which helps give the point motor a good boost of power without draining too much from the DCC supply all at once.
The point motor simply connects to the PC1 module with the 3 wires usually fitted and the module connected by 2 wires to a nearby piece of track or the DCC controller output - thats it! We use screw terminals on all our Point,
Signal and Lighting effects modules to make it easy and quick to connect without needing to solder.
A cover can also be put over the controller.
The module is designed to control a single point motor but two may be safely connected in parallel without damage to the controller, although reliable operation will
depend on the motors used and free movement of points etc so cannot be guaranteed.
To control 4 points see quad point controller PC2
One-Touch DCC™ is a brand new way of instantly controlling your new signals or accessories - NO programming CV codes etc
One-Touch DCC™ is a brand new way of instantly controlling your new signals or accessories - NO programming CV codes.
Uses easy screw terminals - NO soldering
Just connect 2 wires to nearby DCC rails
Use standard solenoid point motors.
Built in CDU for efficient operation.
Dimension 53x34x21mm
Pack contains 1 Single Point Controller and Instructions.
(Photograph shows Track, Point Motor and building which are not included).